Ideas & Design

So now I needed to decide if I was going to start from scratch or use the original wheel in design. A few things were the deciding factors;

* Incorporating the current vibration motors
* Rubber Grips
* the fact the wheel was perfectly symetrical and strong
* the wheel could mount on to the base and use the paddle shifters already

So I decided to use the original wheel although 'hacking' bits off. So I started with some paper designs, which would be laid over the top of the wheel, below is one design as it progressed to become simplier for construction purposes. At this point measurements and accuracy wasnt important it was all about Look and Feel.